BLACK MOLD HELP !!!!!

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #47439
    Mike
    Participant

    Just I suspected water leaking from clogged window channels (before I owned camper) has rotted the O.S.B. flooring on the back of the camper, I was able in one spot to puts a pocket knife clear thru the flooring! Now what, the rest of flooring is good. Any advice, suggestions? I know the flooring and paneling will have to be remove and new installed, luckily the rear of the rig has a fiberglass cap much like the fronts of most fifth wheel’ do. Any input is appreciated.

    #47453
    Paul Boyle
    Participant

    I don’t remember where I was but I saw a wood hardener that would soak in and harden the wood. Epoxy like stuff. You could also brace from below.

    #47455
    Paul Boyle
    Participant
    #47458
    Stephen C Keller
    Participant

    You could also cut out the bad spot and then add a connection piece underneath then place new floor section in. Also would use some glue along with screws to hold everything together. Once dried it would make it one piece again then replace the floor covering.  I have done this process many times when I couldn’t replace the complete floor. In fact it was stronger than the rest by far. You might want to also use a dehumidifier for a while to make sure you get as much moisture out as possible. A few days would make quite a difference.

    #47460
    Stephen C Keller
    Participant

    I should have added that yes they do make a “paint” that will seal any structure pieces like 2/2s in side walls. I have used that before by myself have not had any luck using the epoxy that can be added to the floor and let it reseal and make solid again. Just my experiences from past.

    #47462
    Mike
    Participant

    Stephen you got a name or where to purchase the paint? My 2×2’s in wall are metal but floor joist are pressure treated 2×4’s

     

    #47466
    Stephen C Keller
    Participant

    This is what I used from Menards, Zinsser® Mold Killing Primer

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.